IL-10 Kit ELISA

N° du produit ABIN955899

Le kit ELISA IL-10 (ABIN955899) Rat est un kit ELISA Colorimetric conçu pour quantifier Rat IL-10.

Aperçu rapide pour IL-10 Kit ELISA (ABIN955899)

Antigène: IL-10 (IL10) (Interleukin 10 (IL10))

Reactivité: Rat

Méthode de détection: Colorimetric

Type de méthode: Sandwich ELISA

Gamme de detection: 15.6-1000 pg/mL

Application: ELISA

Détail du produit IL-10 Kit ELISA

Seuil minimal de détection: 15.6 pg/mL

Fonction: This ELISA kit is a sandwich enzyme immunoassay for the in vitro quantitative measurement of Rat IL10 in serum, plasma, cell culture supernates, and other biological fluids.

Analytical Method: Quantitative

Specificité: This assay has high sensitivity and excellent specificity for detection of Rat IL10. No significant cross- reactivity or interference was observed.

Sensibilité: The minimum detectable dose of Rat IL10 is typically less than 4.2 pg/mL.
The Sensitivity of this assay, or Lower Limit of Detection (LLD) was defined as the lowest protein concentration that could be differentiated from zero. It was determined by the mean O.D. value of 20 replicates of the zero calibrator plus three standard deviations.

Attributs du produit: The microtiter plate provided in this kit has been pre-coated with an antibody specific to IL10. Calibrators and samples are then added to the appropriate microtiter plate wells with a biotin-conjugated polyclonal antibody preparation specific for IL10. Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the TMB substrate solution is added to each well. Only those wells that contain IL10, biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of a sulfuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450 nm +/- 2 nm. The concentration of IL10 in the samples is then determined by comparing the O.D. of the samples to the calibration curve.

Ingrédients: Pre-coated, ready to use 96-well plate (1x)
Calibrator (lyophilized) (2x)
Calibrator Diluent (1 x 20 mL)
Detection Reagent A (1 x 120 µL)
Detection Reagent B (1 x 120 µL)
Assay Diluent A (2X concentrate) (1 x 6 mL)
Assay Diluent B (2X concentrate) (1 x 6 mL)
TMB Substrate (1 x 9 mL)
Stop Solution (1 x 6 mL)
Wash Buffer (30X concentrate) (1 x 20 mL)
Plate sealer for 96 wells (4x).

Matériel non inclus: 1. Microplate reader with 450 +/- 10 nm filter.
2. Precision single and multi-channel pipettes and disposable tips.
3. Eppendorf Tubes for diluting samples.
4. Deionized or distilled water.
5. Absorbent paper for blotting the microtiter plate.
6. Container for Wash Solution

Information d'application

Commentaires:

The calibration curve concentrations used for the ELISA's were 1000, 500, 250, 125, 62.5, 31.2, 15.6 pg/mL.

Plaque: Pre-coated

Calcul des résultats:

Average the duplicate readings for each calibrator, control, and sample and subtract the average zero calibrator optical density. Create a calibration curve by reducing the data using computer software capable of generating a four parameter logistic (4-PL) curve-fit. As an alternative, construct a calibration curve by plotting the mean absorbance for each calibrator on the x-axis against the concentration on the y-axis and draw a best fit curve through the points on the graph. The data may be linearized by plotting the log of the IL10 concentrations versus the log of the O.D. and the best fit line can be determined by regression analysis. This procedure will produce an adequate but less precise fit of the data. It is recommended to use some related software to do this calculation. If samples have been diluted, the concentration read from the calibration curve must be multiplied by the dilution factor.

Restrictions: For Research Use only

Stockage

Stock: -20 °C

Stockage commentaire: All reagents should be stored according to their label. The Calibrators, Detection Reagent A, Detection Reagent B and the 96-well plate should be stored at -20° C upon receipt. The unused strips should be kept in a sealed bag with the desiccant provided to minimize exposure to damp air. Opened test kits will remain stable until the expiration date, provided they are stored as above.

Date de péremption: The expiry date is stated on the label.

Détail du antigène

Antigène: IL-10 (IL10) (Interleukin 10 (IL10))

Autre désignation: IL10

Pathways: Cellular Response to Molecule of Bacterial Origin, Regulation of Leukocyte Mediated Immunity, Production of Molecular Mediator of Immune Response, Maintenance of Protein Location, Cancer Immune Checkpoints