Tel:
+49 (0)241 95 163 153
Fax:
+49 (0)241 95 163 155
E-Mail:
orders@anticorps-enligne.fr

SLU7 Kit ELISA

Kit ELISA Humain SLU7, test Colorimetric pour la quantification de Humain SLU7.
N° du produit ABIN6234890

Aperçu rapide pour SLU7 Kit ELISA (ABIN6234890)

Antigène

Tous les produits SLU7
SLU7 (SLU7 Splicing Factor Homolog (SLU7))

Reactivité

Humain

Méthode de détection

Colorimetric

Type de méthode

Sandwich ELISA

Gamme de detection

0.156 ng/mL - 10 ng/mL

Application

ELISA

Type d'échantillon

Cell Lysate, Tissue Homogenate
  • Seuil minimal de détection

    0.156 ng/mL

    Fonction

    Human SLU7 Homolog, Splicing Factor (SLU7) ELISA Kit

    Analytical Method

    Quantitative

    Sensibilité

    < 0.094 ng/mL

    Ingrédients

    The kit components listed are for reference only. The product manual may differ slightly. The product should be used as stated on the product manual included and delivered together with the product.
    • Pre-coated 96-Well Microplate
    • Standard
    • Standard Diluent Buffer
    • Wash Buffer
    • Detection Reagent A
    • Detection Reagent B
    • Diluent A
    • Diluent B
    • TMB Substrate
    • Stop Solution
    • Plate Sealer

    Matériel non inclus

    • 37 °C incubator
    • Multi and single channel pipettes and sterile pipette tips
    • Squirt bottle or automated microplate washer
    • 1.5 mL tubes
    • Distilled water
    • Absorbent filter papers
    • 100 mL and 1 liter graduated cylinders
    • Microplate reader (wavelength: 450 nm)
    • ELISA Shaker
  • Indications d'application

    Optimal dilutions/concentrations should be determined by the end user.

    Commentaires

    The stability of the kit is determined by the rate of activity loss. The loss rate is less than 5 % within the expiration date under appropriate storage conditions. To minimize performance fluctuations, operation procedures and lab conditions should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same user throughout.

    Plaque

    Pre-coated

    Préparation des réactifs

    This procedure is provided for reference only. The product manual may differ slightly. The product should be used as stated on the product manual included and delivered together with the product.

    • 1) Standard: Prepare the standard with the recommended volume of Standard Diluent Buffer, to make the standard solution. Then use the Standard Diluent buffer to carry out serial dilutions of the standard solution, as instructed in the Protocol.
    • 2) Wash Buffer: Dilute the concentrated Wash Buffer with distilled water, as instructed in the Protocol.
    • 3) Detection Reagent Preparation: Calculate the total volume of working solution required. Dilute Detection Reagent A and Detection Reagent B with Diluent A and Diluent B, respectively, at 1:100.

    Prélèvement de l'échantillon

    • Serum: Samples should be collected into a serum separator tube. Coagulate the serum by leaving the tube undisturbed in a vertical position overnight at 4 °C or at room temperature for up to 60 minutes. Centrifuge at approximately 1000 x g for 20 min. Analyze the serum immediately or aliquot and store at -20 °C or -80 °C.
    • Plasma: Collect plasma using heparin or EDTA as an anticoagulant. Centrifuge for 15 minutes at 1000 x g within 30 minutes of collection. Assay immediately or aliquot and store at -20 °C or -80 °C. Avoid hemolysis and high cholesterol samples.
    • Tissue homogenates: The preparation of tissue homogenates will vary depending upon tissue type - this is just an example. Rinse tissues with ice-cold PBS to remove the excess of blood. Weigh before homogenization. Finely mince tissues and homogenize with a tissue homogenizer on ice in PBS and sonicate the cell suspension. Centrifuge the homogenates at 5000 x g for 5 min and collect the supernatant. Assay immediately or aliquot and store at -20 °C.

    Restrictions

    For Research Use only
  • Stock

    4 °C

    Stockage commentaire

    Shipped at 4 °C. Upon receipt, store the kit according to the storage instruction in the kit's manual.

    Date de péremption

    6 months
  • Antigène Tous les produits SLU7

    SLU7 (SLU7 Splicing Factor Homolog (SLU7))

    Autre désignation

    SLU7 Homolog, Splicing Factor

    Classe de substances

    Influenza Protein

    Sujet

    Ensembl: ENSG00000164609

    UniProt Entry Name: SLU7_HUMAN

    ID gène

    10569

    HGNC

    16939

    OMIM

    605974

    UniProt

    O95391

    Pathways

    Ribonucleoprotein Complex Subunit Organization, SARS-CoV-2 Protein Interactome
Vous êtes ici:
Chat with us!